Performing Advanced Setup Of The Media; Setting The Height Of The Media Manually - Roland VersaUV LEF-20 Master Manual

Performing Advanced Setup of the Media

Setting the Height of the Media Manually

Manually set the height of the media for printing .
Although the manual setting takes a little longer than the automatic setting because you need to visually set
the height, it is suitable when you do not want the head gap sensor to come in contact with the media and
when you want to set the distance between the heads and the media .
* If the print surface is uneven, there is a limit to the area of unevenness .
" "Height Settings When the Print Surface is Uneven" (P . 9)
NOTE
Be sure to hold the handle of the front cover and open and close it gently .
Procedure
1.
Secure the media in place on the flat table .
" "1 . Loading Media (Media Setup)" (First Step Guide)
2.
Close the front cover .
SETUP MEDIA
3.
Press [SETUP] .
[SETUP] starts to flash .
4.
Press [ ], [ ], [UP], or [DOWN] to move the flat table .
Move the head gap sensor as close as possible to the print surface .
This step can be performed with the front cover open .
NOTE
Set the height of the table in a way that the highest position of the media (print surface) will not come into
contact with the head gap sensor .
HEIGHT:000.0mm
8
Chapter 1 Fully Utilizing the Machine
Head gap
sensor
Media
Get as close as
you possibly
can .