Setting the Print Area for Each Setup of Media
Usually, when you set up the media, the print area and the base position from the previous setup are set .
You can change them every time you set up the media .
Procedure
1.
Press [MENU] .
2.
Press [ ] to display the screen shown below .
MENU
SUB MENU
3.
Press [ ] twice .
SET AT SETUP
ENABLE
DISABLE
4.
Press [ ] or [ ] to select a value .
SET AT SETUP
DISABLE
(default setting)
ENABLE
5.
Press [ENTER] .
6.
Press [MENU], then [ ] to go back to the original screen .
Explanation
Setup is performed using the print area of the previous setup .
The factory default print area is the full area (508 × 330 mm [20 × 13 in .]) .
This setting is suitable when you always perform printing on media of a fixed size .
Set the print area (base position, width, and length of the print area) every time you set
up the media .
Select this value when the media shape changes for each printing operation .
Performing Advanced Setup of the Media
Chapter 1 Fully Utilizing the Machine
11