Fully Utilizing Convenient Functions; Continuing Printing Even If Media Comes; Into Contact With The Head Gap Sensor - Roland VersaUV LEF-20 Master Manual

Fully Utilizing Convenient Functions

Continuing Printing Even If Media Comes

into Contact with the Head Gap Sensor

This setting allows the height to be readjusted
automatically to continue printing even when
the media moves out of position or lifts up
and comes into contact with the head gap
sensor during printing .(*)
This function is effective when using media
that cannot be reprinted on .
Procedure
1.
Press [MENU] .
2.
Press [ ] to display the screen shown below .
MENU
SUB MENU
3.
Press [ ] .
4.
Press [ ] several times to display the screen
shown below .
SUB MENU
CLEARANCE MODE
5.
Press [ ] .
CLEARANCE MODE
CANCEL RE-ADJ.
6.
Press [ ] or [ ] to select "RE-ADJ . "
C L E A R A N C E
Explanation
MODE
RE-ADJ
CANCEL
(default setting)
20
Chapter 1 Fully Utilizing the Machine
The height is readjusted and print-
ing continues even when the media
comes into contact with the head
gap sensor during printing .
Printing and setup will be canceled
when the media comes into contact
with the head gap sensor during
printing .(**)
7.
Press [ENTER] .
8.
Press [MENU], then [ ] to go back to the
original screen .
Description
When the height is readjusted automatically
and printing continues, the height setting is
changed . Therefore, the print quality may be
changed . Hence, proper printing requires that
the media be secured properly before printing
to keep it from moving out of position or
lifting up .
" "1 . Loading Media (Media Setup)" (First
Step Guide)
" "2 . Setting the Height of the Media
Automatically" (First Step Guide)
" "Setting the Height of the Media Manually"
(P . 8)
At the time when the height is readjusted
automatically, the head gap sensor comes
into contact with the media .
Even if "RE-ADJ" is selected, printing and
setup will be canceled int he following cases .
(**)
• When the flat table descends 10 mm (0 .4 in .)
or more during automatic readjustment
• When the media comes into contact with
the head gap sensor during automatic
readjustment, even if the flat table has
moved to the bottom
(*) For more information on operation after
printing is finished, refer to "READJUST TABLE
HEIGHT" (P . 64) .
(**) For more information on operation after
printing is canceled, refer to "CANCELED FOR
TABLE HEIGHT" (P . 65) and "CHECK TABLE
HEIGHT" (P . 65) .