Section 3: Meter maintenance
January 2018
Procedure
1.
Figure 3-25 Band shroud hem bend joint
72
Place each half of the band shroud assembly on a flat surface. Position the parts so they
are circular with the ends with bent edges near each other. Guide the bent edges to fit
within each other completing the engagement of the sheet metal hem bend. Be sure
that full engagement is achieved and that the edges of both parts remain on the flat
surface.
A. Front shroud hem joint
B. Back shroud hem joint
Maintenance and Troubleshooting Manual
A.
B.
3-9000-772 Rev B
Installing the shrouds