Section 3: Meter maintenance
January 2018
3.2
Re-wetting the transducers
If the chord signal quality diminishes, re-wet the transducers to improve the signal
strength.Transducer field removal and installation is required if a transducer is fouled or if a
chord failure occurs. NOTE:
Measurement Services technician. Refer to the contact information on the back of this manual
for field service assistance.
Figure 3-7 LT-07 transducer assembly
A. LT-07 transducer assembly (P/N 1-504-90-250) 2.5 inch length
B. Set screw (P/N 1-560-84-117)
C. Lock nut (P/N 1-561-57-146)
D. LT-07 transducer housing (welded into meter body)
E. Cord grip assembly (1-504-90-252)
44
Maintenance and Troubleshooting Manual
This procedure should be performed by a qualified Daniel
A.
3-9000-772 Rev B
B.
E.
Re-wetting the transducers
C.
D.