Figure 2-6 Meter Monitor (Detailed) View - Emerson Daniel 3818 Maintenance And Troubleshooting Manual

Section 2: Troubleshooting
January 2018
Run Daniel MeterLink and open the Meter Monitor (Detailed) view to perform a diagnostics
health check and or adjust parameters for your site requirements. If you wish to use the Monitor
(Detailed) dialog as the default view, click the checkbox in the lower portion of the dialog box

Figure 2-6 Meter Monitor (Detailed) view

The following details the information displayed in this dialog box.
•
•
•
•
•
•
•
•
•
•
20
Flow Properties Table - the table at the top of the Meter Monitor dialog box shows basic
information about the condition of the flow in the meter.
Flow Velocity/Flow Ratios Bar Graph - provides a visual comparison between the
velocities for each chord.
Chord Speeds of Sound Bar Graph - a visual comparison between the speeds of sound
for each chord.
Gain/Performance Bar Graph - provides either a visual comparison of the average
upstream and downstream gains for each chord or a visual comparison of the average
upstream and downstream performance for each chord.
Signal to Noise Bar Graph - provides a visual comparison between the signal to noise
ratio for each chord direction.
Meter Status Alarms - provides a visual indication of the meter's status.
Run time - displays how long the monitor screen has been collecting data.
Meter Time - the time displayed is the time from the Ultrasonic meter.
(NOTE: If the time displayed has a yellow background, that is an indication that the
meter's time is more than 10 minutes apart from the PC's time.)
Meter Data List - displays read-only data selected from the drop-down list
Chart - the chart utility displays the data collected for the value selected from the Chart
drop-down list.
Maintenance and Troubleshooting Manual
3-9000-772 Rev B
Meter maintenance