Maintenance; General Recommendations; Maintenance Device - Haulotte COMPACT 8 Operating And Maintenance Instructions Manual

Operating and maintenance instructions - COMPACT 8, 8W, 10N, 10, 12
5.1 -

GENERAL RECOMMENDATIONS

Caution!
Do not use the machine as a
welding earth. Do not weld
without disconnecting the
battery's (+) and (-) terminals.
Do not start other vehicles
with the batteries connected.
5.2 -

MAINTENANCE DEVICE

Photo 18
Photo 19
5 -

MAINTENANCE

The maintenance operations indicated in this manual are given for normal
conditions of use.
In difficult conditions: extreme temperatures, high humidity, polluting atmosphere,
high altitude, etc., some operations must be carried out more frequently and
special precautions must be taken. Refer to PINGUELY-HAULOTTE's After
Sales Service.
Only qualified and competent personnel can carry out any work on the machine
and they must comply with the safety instructions relating to the protection of
personnel and environmental protection.
At regular intervals, check the operation of the safety devices:
1°) Tilt: buzzer + stopping (travel cut as well as lifting).
2°) Platform overload - load
This maintenance leg device enables the operator to work without any risk under
the machine.
Procedure : For the COMPACT 8, 10 N (see Photo 18)
Fitting the maintenance leg:
• Park the elevating platform on firm horizontal ground.
• Make sure that the two emergency stop switches are in the " ON " position.
• Turn the chassis's ignition key to the " Chassis " position.
• Position the chassis raising switch upwards so as to elevate the platform.
• Turn the maintenance leg forwards and let it hang vertically on the bottom
pin pivot tube.
• Push the raising switch into the bottom position so as to lower the platform
gradually until the maintenance leg is resting on the bottom pivot tube.
Removing the maintenance leg:
• Push the chassis's raising switch into the top position and raise the platform
gradually until the maintenance leg is disengaged from the bottom pivot tu-
be.
• Turn the maintenance leg backwards so that it is resting in the storage posi-
tion on the cylinder mount.
• Push the chassis's raising switch into the bottom position and lower the plat-
form completely.
Procedure : For the COMPACT 8W, 10, 12 (see Photo 19)
These operations are done on both sides of the lift.
Fitting the maintenance leg:
• Park the elevating platform on firm horizontal ground.
• Make sure that the two emergency stop switches are in the " ON " position.
• Turn the chassis's ignition key to the " Chassis " position.
• Position the chassis raising switch upwards so as to elevate the platform.
• Unscrew, turn the maintenance leg and let it hang vertically.
• Push the raising switch into the bottom position so as to lower the platform
gradually until the maintenance leg is resting on the two fixing points (top
and bottom).
43