State Of Charge Of The Batteries; Hour Counter; Resetting; Alarm : Problem On The Machine - Haulotte COMPACT 8 Operating And Maintenance Instructions Manual

1
3
2
Photo 1
Photo 2
Alarm Number
code of
(MDI) flashes
0 + -
Red
Diode
AL01 3
AL06 6
AL10 2
AL13 6
26
Operating and maintenance instructions - COMPACT 8, 8W, 10N, 10, 12

3.2.2.1 -State of charge of the batteries

The state of charge of the battery is indicated by 5 LEDs:
• When the battery is correctly charged, four green LEDs are on. (item 1 Photo
1)
• When the battery discharges itself, the LEDs go out one by one.
• When the battery is discharged, the red LED (item 2, Photo 1) comes on, rai-
sing is cut but travel remains possible.
• It is compulsory to recharge the batteries otherwise they would be excessi-
vely discharged and damaged.

3.2.2.2 -Hour counter

The hours are counted on the screen (item 3, Photo 1) when the electric pump
unit is operating. At that time the " timer " flashes.

3.2.2.3 -Resetting

This takes place when the battery is correctly recharged

3.2.2.4 -Alarm : Problem on the machine

When there is a problem on the machine
• the operator on the platform is warned by flashes (see Photo 2). The pro-
blem can be identified from the number of flashes (see table below).
• the operator on the ground is warned by a numerical indication. The problem
can be identified from the number displayed on the hour counter's screen
(see table below).
Message on
console
BATTERY • Batteries
LOW otherwise:
• Faulty chopper.
EVP NOT OK • Defective coil or YV7/
YV9 coil's supply.
SERIAL • Incorrect or lack of
ERROR #1 reception of serial card's
signal to chopper.
WEIGHING Problem on the weighing
CARD KO card
EEPROM KO • Fault in the chopper's
EEPROM.
Description
discharged,
•
resetting the emergency stop or
changing station with the key selec-
tor. See Chap. 4.4.2, page 37.
Solution
• Check:
- the batteries
- the charger
- the electric circuit's supply.
• Otherwise, replace the chopper.
• Look for failure on the lifting
cylinders' lowering coil(s).
• Look for failure on:
- the platform console's serial
card;
- the bundle;
- the connections between the
platform's console and the
chopper.
• Other possible reason: incorrect
cabling on the MDI line or the
MDI display.
Leave at least 2 seconds before
• Replace the chopper.