Haulotte COMPACT 8 Operating And Maintenance Instructions Manual page 42

Alarm Number
code of
(MDI) flashes
AL 91 2
AL93 0
AL94 6
AL95 7
AL96 0
AL97 5
AL98 0
AL99 6
28
Operating and maintenance instructions - COMPACT 8, 8W, 10N, 10, 12
Message on
console
Incorrect configuration of
the "Standard" and
"Europe" software
VERSION NOT
versions.
OK
The "version" and "ok for
version" parameters are dif-
ferent.
WRONG • The platform console's
INPUT ENABLE starting switch is
CONF. closed while a movement
is requested from the chas-
sis control panel.
MICRO • The Siemens calcula-
CONTROL tor does not respond
KO correctly.
PRESSURE • Pressure sensor alarm.
NOT OK
HEIGHT 8
Maximum height reached.
METERS
CURR. • Current out of control.
PROTEC-
TION
• The hour shown on the
MDI and the chopper differ.
CHECK UP • The 'Check up' func-
NEEDED tion has been activated.
Description
•
Solution
Set the two parameters:
- to 2 to activate weighing.
- to 1 to configure weighing
from the bottom station.
• Replace the chassis control
panel's lift switch.
• Replace the chopper.
• Check:
- the continuity of the cable
bundle between the weighing
card and the variator.
• Check input 36.
• Replace the chopper.
• Wait for 6 minutes after putting
into service.
• If the problem remains, connect
the console instead of the MDI.
• In this configuration, if the ma-
chine functions again, MDI fault.
• If the machine still does not
function, defective bundle or
chopper.
• Deactivate the 'CHECK UP
ENABLE' function using the
console.