Offloading With Ramps; Loading; Transport Instructions; Operations Before First Putting Into Service - Haulotte COMPACT 8 Operating And Maintenance Instructions Manual

Operating and maintenance instructions - COMPACT 8, 8W, 10N, 10, 12
Caution!
Never stand under or too
close to the machine during
operations.
Caution!
Do not go down ramps in high
speed mode.
4.3 -

OPERATIONS BEFORE FIRST PUTTING INTO SERVICE

4.2.2 - Offloading with ramps

Precautions : Make sure that:
• the machine is totally folded.
• the ramps can support the load and that adherence is sufficient to avoid any
risk of slipping during the operation and that they are correctly fixed.
IMPORTANT: Since this method requires the machine to be switched on, refer to
Chapter 4.3, page 33 to avoid any risk of incorrect operation.
Select low travel speed.
NOTE : For ramps over 25%, the battery tray may well hit the ground. If the
slope is greater than the maximum travel slope, use a hoist in addi-
tion to traction or retention.

4.2.3 - Loading

The precautions are identical to the offloading precautions.
The machine must be secured in accordance with the sketch below.
To go up a lorry's ramps, select low travel speed.

4.2.4 - Transport instructions

• When transporting the machines, make sure that the capacities of the vehi-
cle, of the loading surfaces and of the straps and ties are sufficient to take
the weight of the machine.
• The machine must be on a level surface or attached before the brakes are
released.
During its manufacture, each lift is the subject of continuous quality controls.
Transport can cause damage. You must report any damage to the carrier before
the machine is put into service for the first time.
REMINDER :Before any operation, familiarise yourself with the machine by refer-
ring to this manual, the engine's manual, and the instructions on the
various plates.
33