CEStronics Omega Active Programming Instructions Manual page 53

Opening locking devices
Hold the RF-STICK-MASTER within reading range of your

locking device.
If required, wake up your locking device by slightly turning

the outside knob (for IES fittings: put your finger on the
reading sensor).
To ensure a fault-free data transmission, there
must not be any obstacles interfering with the
radio transmission between your locking device
and the RF-Stick, otherwise the transmission will
be aborted.
If the distance between the RF-Stick and the
locking device is too long (longer than 10 m), the
locking device will signal the lacking connection
with a long beep and red LEDs.
When the locking device has detected the RF-STICK-MASTER,
it signals this with a long beep and the green LEDs will go on
for about five seconds.
When the transmission starts, the green LEDs start flashing
and continue to flash until the data transmission is finished.
After the data transmission has been finished, the
programming job is deleted from the "Programming status"
list.
OMEGA ACTIVE Programming Instructions
The progress of the data transmission
can be observed in the "Programming
status" window.
53