CEStronics Omega Active Programming Instructions Manual page 28

Deleting the authorization of a locking medium
You can delete the authorization of individual locking media or
of all locking media. For this purpose, you require the
PROGRAM-MASTER that was originally used to grant the
authorization.
To delete the authorization of individual locking media,
proceed as follows:
Rotate the outside knob of the locking cylinder by at least

one notch or touch the proximity sensor.
Hold the PROGRAM-MASTER in front of the reader.

The LED signals green as long as the PROGRAM-MASTER is
within reading range. When you leave the range, this is
signalled with a short beep.
Hold the locking medium the authorization of which you

want to delete in front of the reader until you hear two short
beeps.
The LED signals green as long as the locking medium is within
reading range.
After you have heard the signal, remove the locking

medium from the reader.
If you want to delete the authorization of additional locking

media, hold them successively in front of the reader.
To complete the deletion process, again hold the PROGRAM-

MASTER in front of the reader for a short moment.
The LED signals green as long as the PROGRAM-MASTER is
again within reading range. When you leave the reading range
you hear a long beep and the authorization of the locking
medium or media has been deleted.
28
OMEGA ACTIVE Programming Instructions
Basic programming routine