Table of Contents
Advertisement
Basic programming routine
Granting authorizations
ATTENTION
Danger of accidental deletion of
authorizations.
Defining the SYSTEM-MASTER
To define the SYSTEM-MASTER for the locking device, proceed
as follows:
Hold the SYSTEM-MASTER in front of the reader.
Rotate the outside knob of the locking cylinder by at least
one notch or touch the proximity sensor.
The LED signals green as long as the SYSTEM-MASTER is
within reading range.
Remove the SYSTEM-MASTER for a short moment.
When the SYSTEM-MASTER has left the reading range, this is
signalled with a short beep.
To confirm, hold the SYSTEM-MASTER again in front of the
reader for a short moment.
Remove the SYSTEM-MASTER.
The LED signals green as long as the SYSTEM-MASTER is again
within the range of the reader. When you leave this range, this
is signalled with a long beep. This completes the programming
of the SYSTEM-MASTER.
You can only define one SYSTEM-MASTER for a
locking cylinder and/or access terminal. If you hold
another SYSTEM-MASTER in front of the reader,
you will hear four short beeps and the LED will
flash red four times.
OMEGA ACTIVE Programming Instructions
Only hold the respective media in front of the
reader for as long as is indicated in the
instructions.
23
Advertisement
Table of Contents
