Deleting Authorizations - CEStronics Omega Active Programming Instructions Manual

Basic programming routine

Deleting authorizations

Deleting the authorization of a PROGRAM-MASTER
To delete the authorization of a PROGRAM-MASTER, you
require the SYSTEM-MASTER. When you delete the
authorization of the PROGRAM-MASTER, all the authorizations
of locking media that were granted with that PROGRAM-
MASTER are deleted as well. Proceed as follows:
Rotate the outside knob of the locking cylinder by at least

one notch or touch the proximity sensor.
Hold the SYSTEM-MASTER in front of the reader.

The LED signals green as long as the SYSTEM-MASTER is
within reading range. When you leave the range, this is
signalled with a short beep.
Now hold the PROGRAM-MASTER in front of the reader.

The LED signals green as long as the PROGRAM-MASTER is
within reading range. After about ten seconds you hear two
short beeps.
Now remove the PROGRAM-MASTER from the reader.

To complete the deletion process, hold the SYSTEM-MASTER

in front of the reader again.
The LED signals green as long as the SYSTEM-MASTER is again
within the range of the reader. When you leave the range, this
is signalled with a long beep. The authorization of the
PROGRAM-MASTER has now been deleted.
OMEGA ACTIVE Programming Instructions
27