CEStronics Omega Active Programming Instructions Manual page 33

Optional Master media
RELEASE-MASTER
With the RELEASE-MASTER, you can set locking cylinders,
shields or wall terminals into enable condition. In enable
condition, no locking media are read and the locking devices
are permanently open.
 The cylinder or shield allows permanent access.
 The relay of the wall terminal is permanently pulled up.
To set the enable condition:
Rotate the outside knob of the locking cylinder by at least

one notch or touch the proximity sensor.
Hold the RELEASE-MASTER for about two seconds in front of

your locking device (Confirmation: 1 x short signal).
Deactivate enable condition:
Rotate the outside knob of the locking cylinder by at least

one notch or touch the proximity sensor.
Hold the RELEASE-MASTER for about five seconds in front of

your locking device (Confirmation: 2 x short signal).
In response, your locking cylinder uncouples and/or the relay
of the wall terminal drops. The enable condition is also
terminated when you hold the BLOCK-MASTER in front of your
locking cylinder or wall terminal as described below.
OMEGA ACTIVE Programming Instructions
33