CEStronics Omega Active Programming Instructions Manual page 40

To set the RF mode (Online mode) of your locking devices
with the RF-INI-MASTER, proceed as follows (see also page
62):
Turning the outer knob of the cylinder to at least a notch

point or touch the proximity sensor.
Keeping the RF INI MASTER about two seconds before your

locking device.
As a result, you get a short green signal and a short sound.
Turning the outer knob of the cylinder to at least a notch

point or touch the proximity sensor.
Keeping the RF INI MASTER again longer before your

locking device.
As result you get the green signal for about five seconds, as

well as an acoustic signal.
The online mode is now turned on.
To put your locking device in the offline mode, proceed as
follows:
Turning the outer knob of the cylinder to at least a notch

point or touch the proximity sensor.
Keeping the RF INI master before the locking device, until

the following signaling is finished.
As a result, you get the green signal for about five seconds, as
well as an acoustic signal. After a brief pause given again two
short acoustic signals. Then the green signal goes out and the
acoustic signal is terminated.
The offline mode is now turned on.
40
OMEGA ACTIVE Programming Instructions
Online programming