CEStronics Omega Active Programming Instructions Manual page 34

BLOCK-MASTER
With the BLOCK-MASTER, you can set your locking devices
permanently into blocked condition. In blocked condition all
locking media are rejected. 
 The locking cylinder is permanently blocked and prevents
access.
 The relay of the wall terminal is permanently dropped.
To set the blocked condition:
Rotate the outside knob of the locking cylinder by at least

one notch or touch the proximity sensor.
Hold the BLOCK-MASTER for about two seconds in front of

your locking device (Confirmation: 1 x short signal).
Deactivate blocked condition:
Rotate the outside knob of the locking cylinder by at least

one notch or touch the proximity sensor.
Hold the BLOCK-MASTER for about five seconds in front of

your locking device (Confirmation: 2 x short signal).
The optional transponder cards RF-INI-MASTER
and RF-TRACE-MASTER do not require
authorization with a SYSTEM-MASTER. Their
function is performed immediately when they are

within range of a reader.
The function is deleted by holding the respective
card again within range of the reader.
34
OMEGA ACTIVE Programming Instructions
Optional Master media