Parameterization Of The Device - ABB TTH200 Operating Instruction

TTH200 HEAD-MOUNT TEMPERATURE TRANSMITTER | OI/TTH200-EN REV. B
The device is listed with the FieldComm Group.
1 Transmitter
2 Handheld terminal
3 HART® modem
4 PC with Asset Management Tool
Figure 16: Example for HART connection
Manufacturer ID
Device Type ID
Profile
Configuration
Transmission signal
Operating modes
• Point-to-point communication mode –
standard (general address 0)
• Multidrop mode (addressing 1 to 15)
• Burst Mode
Diagnosis notice
• Overrange / underrange in accordance with NE 43
• HART® diagnosis
Change from two to one column
5 Grounding (optional)
6 Power supply unit
(process interface)
R load resistance
B
(if necessary)
HART® 5.1
DTM, EDD, FDI (FIM)
BELL Standard 202

Parameterization of the device

Note
The device does not have operating elements for
parameterization on site.
Parameterization takes place via the HART interface.
Parameterization of the device takes place via standard HART®
tools. These include:
• ABB Handheld HART® Communicator DHH805
(TTX200 EDD)
• ABB Asset Vision Basic (TTX200 DTM)
• ABB 800xA Control system (TTX200 DTM)
• ABB Field Information Manager / FIM
(TTX200 EDD, TTX200 Package)
• Other tools supporting standard HART® EDDs or DTMs
(FDT1.2)
Note
Not all tools and frame applications support DTMs or EDDs at
the same level. In particular, optional or advanced EDD / DTM
0x1A functions may potentially not be available on all tools.
0x0D ABB provides frame applications supporting the full range of
functions and performance.
21