Factory Settings - ABB TTH200 Operating Instruction

24 TTH200 HEAD-MOUNT TEMPERATURE TRANSMITTER | OI/TTH200-EN REV. B
... 9 Commissioning
... Parameterization of the device

Factory settings

The transmitter is configured at the factory. The table below contains the relevant parameter values.
Menu
Device Setup
Process Alarm
Change from one to two columns
Designation
Write protection
Input
Parameter
-
Sensor Type
R-Connection
Measured Range Begin
Measured Range End
Engineering Unit
Damping
Fault signaling
Factory setting
No
Pt100 (IEC60751)
Three-wire circuit
0
100
Degrees C
Off
Overrange 22 mA