Alvarion BreezeNET B System Manual page 164

Chapter 4 - Operation
4.2.6.3.7.1 Send SNMP Traps
The Send SNMP Traps option enables or disables the sending of SNMP traps.
The default selection is Disable.
4.2.6.3.7.2 SNMP Traps Destination IP Addresses
The SNMP Traps Destination IP Addresses submenu enables defining up to 10 IP
addresses of devices to which the SNMP Traps are to be sent.
The default of all 10 SNMP Traps IP destinations is 0.0.0.0.
4.2.6.3.7.3 SNMP Traps Community
The SNMP Traps Community option enables defining the Community name for
each IP address to which SNMP Trap messages are to be sent.
Valid strings: Up to 8 ASCII characters.
The default for all 10 addresses is "public", which is the default Read community.
4.2.6.3.7.4 Delete One Trap Address
The Delete One Trap Address option enables deleting Trap address entries from
the SNMP Traps Addresses list.
4.2.6.3.7.5 Delete All Trap Addresses
The Delete All Trap Addresses option enables deleting all entries from the SNMP
Traps Addresses list.
4.2.6.3.8 Wi2 IP Address (RB Only)
This parameter is intended for future use to support solutions where BreezeNET B
serves as a backhaul link for a WiFi Access Point. The Wi2 IP Address parameter
enables the installer to configure in the RB the IP address of the WiFi AP
connected to it, providing availability of the IP address information for remote
management of the AP.
The default Wi2 IP Address is 0.0.0.0 (meaning none).
4.2.6.4 Bridge Parameters
The Bridge Parameters menu provides a series of parameter sets that enables
configuring parameters such as control and filtering options for broadcast
transmissions, VLAN support, and Type of Service prioritization.
The Bridge Parameters menu includes the following options:
VLAN Support

Ethernet Broadcast Filtering

BreezeNET B 140
Menus and Parameters
System Manual