Table of Contents
Advertisement
2 GETTING STARTED
This section of the instructions is intended for first-time users of the
Elcometer 3000 Clemen Unit. It describes the steps you must take before you
can start using the unit and offers advice on safe operation.
2.1 Installation
Place the Elcometer 3000 Clemen Unit onto a rigid table. The motorised model
includes adjustable feet which can be used to level the unit.
2.2 The parts of your tester
1
2
Figure 1. The parts of your tester (manual model shown)
1. Weight
2. Clamp
3. Load beam
4. Tool
5. Sample platform
2.3 Power input
(These instructions apply to motorised models only)
The power input panel is protected by two fuses - see "Technical specification"
on page 14 for fuse rating.
4
R
3
4
5
Advertisement
Table of Contents
