2.4 Control panel
(These instructions apply to motorised models only)
Voltmeter
•
To switch on the Clemen Unit, press the Power On/Off button. The button
will illuminate when the Clemen Unit is switched on. Press again to switch
the tester off.
•
To start the tool movement, press the Start button. The tool will stop
automatically at the end of its stroke. To stop the movement at any time,
press the Power On/Off button. The light in the Start button will flash when
coating has been removed completely from a metallic sample - see page 9.
2.5 Caution
The Elcometer 3000 Clemen Unit has been manufactured with your safety in
mind. However, improper use can result in damage to the tester.
Please observe the precautions discussed in these operating instructions.
To reduce the risk of electric shock, do not open the housing of the
Elcometer 3000/3 Motorised Clemen Unit. There are no user-
serviceable parts inside.
To reduce the risk of fire or electric shock, do not expose the Elcometer 3000/
3 Motorised Clemen Unit to rain or excess moisture.
The mains plug on your Elcometer 3000/3 Motorised Clemen Unit may be fitted
with a fuse. When replacing this fuse, ensure a fuse of the correct rating is used.
Start
Figure 2. Control panel
ON
OFF
Power
on/off
R
5