Fcc/Ised Regulatory Notices - Quectel EG91 Series Hardware Design

1.2. FCC/ISED Regulatory notices

Modification statement
Quectel has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user's
authority to operate the equipment.
Quectel n'approuve aucune modification apportée à l'appareil par l'utilisateur, quelle qu'en soit la nature. Tout changement ou
modification peuvent annuler le droit d'utilisation de l'appareil par l'utilisateur.
Interference statement
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
RF exposure
This equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment. The
antenna should be installed and operated with minimum distance of 20 cm between the radiator and your body. Antenna
gain must be below:
Antenna Gain
WCDAM II:≤9.000dBi
❒
WCDAM V:≤6.000dBi
❒
WCDAM VIII:≤10.416dBi
❒
❒ LTE Band2:≤8.500dBi
❒ LTE Band4:≤5.500dBi
❒ LTE Band5:≤9.916dBi
❒ LTE Band12:≤9.234dBi
❒ LTE Band13:≤9.673dBi
❒ L TE Band25:≤8.500dBi
❒ L TE Band25:≤9.837dBi
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The host end product must include a user manual that clearly defines operating requirements and conditions that must be
observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to above, a separate approval is required to satisfy the SAR requirements of FCC Part
2.1093.
If the device is used for other equipment that separate approval is required for all other operating configurations, including
portable configurations with respect to 2.1093 and different antenna configurations.
Cet appareil est conforme aux limites d'exposition aux rayonnements de l'ISED pour un environnement non contrôlé.
L'antenne doit être installé de façon à garder une distance minimale de 20 centimètres entre la source de rayonnements et
votre corps. Gain de l'antenne doit être ci-dessous:
Gain de l'antenne
EG91_Hardware_Design 13 / 93
LTE Module Series
EG91 Hardware Design