Fcc Requirement; Fcc Regulations; Rf Exposure Information; Important Note - Quectel SC20-AD Manual

Lte module

Table of Contents

FCC Requirement

1.1

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) This device must accept any interference received, including interference that

may cause undesired operation.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the

possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than

20cm (8 inches) during normal operation.

This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance requirement of

the end product, which integrates this module. 20cm minimum distance has to be able to be maintained between the

antenna and the users for the host this module is integrated into. Under such configuration, the FCC radiation exposure

limits set forth for an population/uncontrolled environment can be satisfied.

Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this

equipment.

SC20-E_Manual_R1.0

Confidential / Released

48 / 57

Table of Contents

Sc20 series