Quectel EG91 Series Hardware Design page 15

WCDAM II:≤9.00dBi
❒
WCDAM V:≤6.00dBi
❒
WCDAM VIII:≤7.15dBi
❒
❒ LTE Band2:≤8.50dBi
❒ LTE Band4:≤5.50dBi
❒ LTE Band5:≤6.64dBi
❒ LTE Band12:≤6.15dBi
❒ LTE Band13:≤6.44dBi
❒ L TE Band25:≤8.50dBi
❒ L TE Band25:≤6.63dBi
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou autre émetteur.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Labelling Requirements for the Host device
The host device shall be properly labelled to identify the modules within the host device. The certification label of the
module shall be clearly visible at all times when installed in the host device, otherwise the host device must be labelled to
display the FCC ID and ISED of the module, preceded by the words "Contains transmitter module", or the word "Contains",
or similar wording expressing the same meaning, as follows:
Contains FCC ID：XMR201903EG91NS
Contains IC: 10224A-20193EG91NS
The host OEM user manual must also contain clear instructions on how end users can find and/or access the module and
the FCC ID and ISED.
L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des modules qui s'y trouvent. L'étiquette de
certification du module donné doit être posée sur l'appareil hôte à un endroit bien en vue en tout temps. En l'absence
d'étiquette, l'appareil hôte doit porter une étiquette donnant le FCC ID et l'ISED du module, précédé des mots « Contient un
module d'émission », du mot « Contient » ou d'une formulation similaire exprimant le même sens, comme suit :
Contient FCC ID：XMR201903EG91NS
Contient IC: 10224A-20193EG91NS
Le manuel d'utilisation OEM de l'hôte doit également contenir des instructions claires sur la manière dont les utilisateurs
finaux peuvent trouver et / ou accéder au module et à l'ID FCC et l'ISED.
EG91_Hardware_Design 14 / 93
LTE Module Series
EG91 Hardware Design