Input Tags - Allen-Bradley Compact 5000 Series User Manual

Appendix B Module Tag Definitions
Table 60 - 5069-IA16 Module Input Tags
Name
RunMode
ConnectionFaulted
DiagnosticActive
DiagnosticSequenceCount
Ptxx.Data
Ptxx.Faults
Ptxx.Uncertain
234

Input Tags

Table 60 describes the 5069-IA16 module input tags.
Data Type Definition
BOOL Channel's operating state
BOOL Indicates if a connection is running.
The module sets this tag to 0 when connected. If the
module is not connected, it changes the tag to 1.
BOOL Indicates if any diagnostics are active or if the prognostics
threshold is reached.
SINT Increments for each time a distinct diagnostic condition is
detected, and when a distinct diagnostic condition
transitions from detected to not detected.
Set to zero by product reset or power cycle. Wraps from
255 (-1) to 1 skipping zero.
BOOL Indicates the current input value.
BOOL Indicates that channel data is inaccurate and cannot be
trusted for use in the application.
For more information, see
on page 71.
BOOL Indicates that the channel data can be inaccurate but the
degree of inaccuracy is not known.
For more information, see
on page 71.
Rockwell Automation Publication 5069-UM004A-EN-P - April 2019
Valid Values
• 0 = Idle
• 1 = Run
• 0 = Connection running
• 1 = Connection not running
• 0 = No diagnostics active
• 1 = One or more diagnostics are active or the
prognostics threshold is reached
• -128...+127
The value of 0 is skipped except during module
power-up.
• 0 = Off
• 1 = On
• 0 = Good data
• 1 = Bad data (Faulted)
Module Data Quality Reporting
If the tag is set to 1, you must troubleshoot the
module to correct the cause of the inaccuracy.
IMPORTANT: Once the condition that causes
the tag to change to 1 is removed, the tag
automatically resets to 0.
• 0 = Good data
• 1 = Uncertain data
Module Data Quality Reporting
If the tag is set to 1, you must troubleshoot the
module to correct the cause of the inaccuracy.
IMPORTANT: Once the condition that causes
the tag to change to 1 is removed, the tag
automatically resets to 0.