Installing Your 220V Ac Digital Input Or Output Module - Allen-Bradley 1794-IM8 Installation Instructions Manual

Installing Your 220V AC Digital Input or Output Module

4
Description
1 Keyswitch
2 Terminal base
3 Flexbus connector
4 Module
The module mounts on a 1794 terminal base.
ATTENTION: During mounting of all devices, be sure that all debris (metal chips,
wire strands, etc.) is kept from falling into the module. Debris that falls into the
module could cause damage on power up.
1. Rotate the keyswitch (1) on the terminal base (2) clockwise to position
as required for this type of module.
2. Ensure that the Flexbus connector (3) is pushed all the way to the left to
connect with the neighboring terminal base/adapter. You cannot install
the module unless the connector is fully extended.
3. Make sure the pins on the bottom of the module are straight so they will
align properly with the connector in the terminal base.
Rockwell Automation Publication 1794-IN104C-EN-P - July 2018
FLEX I/O 220V AC Digital Input and Output Modules
3
Description
5 Alignment bar
6 Groove
7 Latching mechanism
7
1
2
6
5
8
7