Manual Longitudinal Travel Operation; Patient Restraint Strap - OAKWORKS DTPM 300 User Manual

Imaging table
Table of Contents

Advertisement

DIRECTIONS FOR USE
M A N U A L L O N G I T U D I N A L T R A V E L O P E R A T I O N
CAUTION
The table is designed to allow travel in either the left or the right direction as shown. This feature
should only be used when the table is level.
LOCKING KNOB OPERATION
A Locking Knob is provided on each side of the table just
under the side rail.
Rotate the locking knob several turns counter-clockwise
to loosen. Slide the table in the desired direction. Rotate
the locking knob clockwise until tight to secure the table
against traveling.
P A T I E N T R E S T R A I N T S T R A P
CAUTION
The strap has Hook and Loop Faster attached to the ends. The Strap is attached as follows:
1. Place the center of each strap around the patient at
two places. Relocate the straps as necessary for adequate
clearance.
2. Take the ends of each strap down around the tabletop.
Pull each strap snug underneath the table and press the two
ends together.
3. Check both straps to assure adequate patient restraint
prior to using the Trendelenburg functions.
When operating the table's locking knob be sure to avoid pinching. Keep your fingers and
other materials clear from the pinch point. Both locking knobs must be securely tightened at
all times - Travel can occur if the locking knobs are not secured by inadvertently pushing on
the end of the table or by tilting the table.
Left - Right Travel ± 11.5" (29 cm.)
The Patient Restraint Strap must be used during all procedures to prevent
the patient from falling off the table.
8

Advertisement

Table of Contents
loading

Table of Contents