Configuring Scene Change Events - Honeywell H4L6GR2 User Manual

Ultra HD IP Camera User Guide
8.
9.
10. Click Save to apply the settings.

Configuring Scene Change Events

You can configure scene change event settings on the Setup > Video Analytics > Video
Detection > Scene Change page.
To enable scene change detection:
1.
2.
3.
4.
5.
6.
7.
48
To send an email notification when a tampering event is detected, select the Send
Email check box. Email settings must be configured in Setup > Network Setup > SMTP
(Email). See Configuring Email Settings
To take a snapshot when a tampering event is detected, select the Snapshot check box.
Note For the snapshot to be attached to the email notification, the Attachment
check box must be selected in Setup > Network Setup > SMTP (Email).
See Configuring Email Settings
Select the Enable check box.
Next to Alarm Period, click Setup. The Alarm Period window opens.
Set the days and times when you want the alarm function to be active, and then click
Save.
To start recording video when a scene change event is detected, select the Record
check box.
In the Record Delay field, enter the number of seconds that the system will continue to
record video after a scene change event has ended. Enter a value between 10 and 300.
To generate an alarm output when a scene change event is detected, select the Alarm
Output check box and select the alarm output(s) to be activated.
In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after a scene change event has ended. Enter a value between
10 and 300.
on page 35.
on page 35.