Honeywell H4L6GR2 User Manual page 52

Ultra HD IP Camera User Guide
3.
4.
5.
6.
7.
8.
9.
10. In the Alarm Delay field, enter the number of seconds that the system will continue to
11. To send an email notification when an alarm event is detected, select the Send Email
12. To take a snapshot when an alarm event is detected, select the Snapshot check box.
13. Click Save to apply the settings.
42
Next to Alarm Period, click Setup. The Alarm Period window opens.
Set the days and times when you want the alarm function to be active, and then click
Save.
In the Anti-Dither field, enter the anti-dither time in seconds. Enter a value between 0
and 100 seconds. The system will only allow one alarm event within this period.
Set Sensor Type to NO (normally open) or NC (normally closed), depending on the
alarm input type.
To start recording video when an alarm event is detected, select the Record check box.
In the Record Delay field, enter the number of seconds that the system will continue to
record video after an alarm event has ended. Enter a value between 10 and 300.
To generate an alarm output when an alarm event is detected, select the Alarm Output
check box and select the alarm output(s) to be activated.
generate an alarm output after an alarm event has ended. Enter a value between 10 and
300.
check box. Email settings must be configured in Setup > Network Setup > SMTP
(Email). See Configuring Email Settings
Note For the snapshot to be attached to the email notification, the Attachment
check box must be selected in Setup > Network Setup > SMTP (Email).
See Configuring Email Settings
on page 35.
on page 35.