Configuring Video Motion Detection; Table 4-9 Scene Change Threshold Values - Honeywell HD3HDIH User Manual

HD3 EQUIP Series H.264 Indoor High Resolution True Day/Night IP Dome Camera User Guide

Configuring Video Motion Detection

Document 800-07361V3 Rev A
11/2011
Configuring Camera Field of View Change Detection
The web client application can detect tampering of the camera field of view and show an
alarm message above the video display (see
camera field of view:
1. Click the Video Analytics tab.
2. In the Scene Change Threshold list, select one of the following options:
Table 4-9 Scene Change Threshold Values
Value
High (80%)
Medium (50%)
Low (30%)
3. Click Apply.
Note To turn off camera field of view change detection, select Disable in the Scene
Change Threshold list. Disable is the default value.
Note You must click Apply after you make changes to any settings to save those
changes. Settings are not saved unless you click Apply.
For motion detection, an Administrator can enable and configure up to 5 zones within a
scene. The enabled and configured zones will be monitored for motion.
1. Click the Region drop-down menu, then select a region from the five available.
2. Click the VMD drop-down arrow, and select Enable.
The Regions appear in their default positions.
3. Click Apply.
4. Click and drag the box to resize and place it over the camera image.
5. Select the sensitivity level (High, Medium, Low).
Figure 4-17). To detect a change in the
To detect ...
Maximum change in the camera field of view. The alarm
message appears when tampering causes at least an 80%
change in your camera field of view.
Medium change in the camera field of view. The alarm
message appears when tampering causes at least a 50%
change in your camera field of view.
Minimum change in the camera field of view. The alarm
message appears when tampering causes at least a 30%
change in your camera field of view.
65