Configuring Motion Detection Events - Honeywell H4L6GR2 User Manual

To enable illegal access detection:
1.
2.
3.
4.
5.

Configuring Motion Detection Events

You can configure motion detection event settings on the Setup > Video Analytics > Video
Detection > Motion Detection page.
To enable motion detection:
1.
2.
3.
4.
5.
On the Illegal Access tab, select the Enable check box.
In the Failed Login Attempts field, enter the number of unsuccessful login attempts
the system will allow before an illegal access event is detected. Enter a value between 3
and 10.
To generate an alarm output when an event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated.
In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
To send an email notification when an illegal access event is detected, select the Send
Email check box. Email settings must be configured in Setup > Network Setup > SMTP
(Email), See Configuring Email Settings
Select the Enable check box.
Next to Alarm Period, click Setup. The Alarm Period window opens.
Set the days and times when you want the alarm function to be active, and then click
Save.
In the Anti-Dither field, enter the anti-dither time in seconds. Enter a value between 0
and 100 seconds. The system will only allow one motion detection event within the
Anti-Dither period.
Set up motion detection areas:
Configuring Event Settings
on page 35.
45