Configuring System Events; Configuring Sd Card Event Settings; Configuring Network Event Settings - Honeywell H4L6GR2 User Manual

Ultra hd ip camera
Table of Contents

Advertisement

Configuring System Events

You can configure system event settings (for SD card and network errors and illegal login
attempts) on the Setup > Alarm Setup > Event page.

Configuring SD Card Event Settings

There are three types of SD card events:
You can configure settings for each type of event.
To enable SD card event detection:
1.
2.
3.
4.
5.
6.

Configuring Network Event Settings

There are two types of network events:
No SD Card: There is no microSD card installed in the camera.
SD Card Error: The installed microSD card is not working.
Capacity Warning: The installed microSD card is full.
On the SD Card tab, select the event type that you want to configure from the Event
Type list (No SD Card, SD Card Error, or Capacity Warning).
Select the Enable check box.
To generate an alarm output when an event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated.
In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
To send an email notification when the event is detected, select the Send Email check
box. Email settings must be configured in Setup > Network Setup > SMTP (Email). See
Configuring Email Settings
Click Save to apply the settings.
Network Disconnected: The camera is offline.
IP Conflict: The camera has the same IP address as another device on the network.
on page 35.
Configuring Event Settings
43

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hm4l8gr1Hbl6gr2Hmbl8gr1

Table of Contents