100-214-251 IWoper.book Page 69 Friday, June 16, 2017 4:12 PM
4.11.1 Setting DIP Switches
WARNING
• Open the left side cover to access the DIP switches which are located on the circuit board located
on the lower right corner immediately behind the front panel.
• Use an insulated probe to alter DIP switch settings.
• After altering a DIP switch, close and secure the left side cover and plug in the power cord.
NOTICE
These settings are different for the IW and the IW+, and read only at power-up.
Figure 4.24DIP Switch Location
100-214-251 REV. 05
General Warning
Be sure the welder is electrically disconnected before opening the
cover.
69