Returning Equipment For Repair - Emerson Branson 2000 Series Instruction Manual

100-214-251 IWoper.book Page 9 Friday, June 16, 2017 4:12 PM
1.5

Returning Equipment for Repair

Before sending equipment for repair, provide as much information with the equipment to
help determine the problem with the system. Use the following page to record necessary
information.
NOTICE
To return equipment to Branson, you must first obtain an RGA number from a Branson
representative, or the shipment may be delayed or refused.
If you are returning equipment to Branson for repair, you must first call the Repair
department to obtain a Returned Goods Authorization (RGA) number. (If you request
it, the repair department will fax a Returned Goods Authorization form to fill out and
return with your equipment.)
Branson Repair Department, C/O Zuniga Logistics, LTD
12013 Sara Road, Killam Industrial Park
Laredo, Texas 78045 U.S.A.
direct telephone number: (877) 330-0405
fax number: (877) 330-0404
• Provide as much information as possible that will help identify the need for repair
• Carefully pack the equipment in original packing cartons
• Clearly label all shipping cartons with the RGA number on the outside of cartons as well as on
your packing slip, along with the reason for return
• Return general repairs by any convenient method. Send priority repairs by air freight
• You must prepay the transportation charges FOB Laredo, Texas, U.S.A.
1.5.1 Get an RGA Number
RGA# _____________
If you are returning equipment to Branson, please call the Danbury Repair Department to
obtain a Returned Goods Authorization (RGA) number. (At your request, the Repair
Department will fax an RGA form to fill out and return with the equipment.)
1.5.2 Record information about the Problem
Before sending equipment for repair, record the following information and send a copy of it
with the equipment. This will greatly increase Branson's ability to address the problem.
1. Describe the problem; provide as much detail as possible.
For example, is the problem intermittent? How often does it occur? How long before it occurs
after powering up?
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
2. Is your equipment in an automated system? NO / YES
3. If the problem is with an external signal, which signal? ______________________
4. If known, include plug/pin # (e.g., P29, pin #3) for that signal: _________________
5. What are the Weld Parameters?
100-214-251 REV. 05 9