Figure 4.7 Mounting Bolt Pattern For The Hub (For Stand On Hub) - Emerson Branson 2000 Series Instruction Manual

100-214-251 IWoper.book Page 51 Friday, June 16, 2017 4:12 PM

Figure 4.7 Mounting Bolt Pattern for the Hub (for Stand on Hub)

3/8 inch or
M10 bolts
(4 places)
2.22 in /
56 mm
Column
Bolts
1. Locate the hub in the desired location. Ensure no overhead or side obstructions will interfere with
normal operation or use of the system.
CAUTION
2. Carefully lift the welder and column assembly, and mount the column in the hub. Align the flat
face of the spring swivel with the top-front of the welder. Tighten the two bolts on the hub
3. Connect factory air to the air input on the rear of the welder. Use a lockout device on the air line
if required
4. Verify the base/start switch control cable is properly connected to the back of welder
5. Use jack screws to fine adjust the system level. A 3/16" Allen wrench should be used for the 3/
8"-16 x 3/4" jack screws
4.5.3 Input Power (Main)
The system requires single-phase input power, which you connect to the Welder using the
integral power cord. See
requirements for your specific power level.
Refer to the unit's Model Data Tag to be sure of the power rating of the Model in your
system.
Open the left side cover door of your welder and locate the Line Voltage Selector Jumper.
figure: Line Voltage Selector Jumper
The voltage select is 100 - 120 or 200-240 Volts, depending on model. You may need to
replace the circuit breaker/power switch to coincide with the voltage setting.
100-214-251 REV. 05
10.50 in / 267 mm
3.94 in / 100mm
0.94 in / 24 mm
(four places)
Rear of Hub
General Warning
Mount the hub to your work surface using four bolts, 3/8-inch or M10
shank size, with flat washers against its metal casting (customer
provided hardware).
Table 4.4 Input Power Requirements
6.00 in / 152 mm
5.25 in / 133 mm
Jack Screws(4)
Front of Hub
for plug and receptacle
Front of Hub
0.59 in /
11 mm
4.44 in /
113 mm
3.25 in /
83 mm
51