Figure 2.4 Front Panel Displays, Iw; Table 2.3 Front Panel Displays, Iw - Emerson Branson 2000 Series Instruction Manual

100-214-251 IWoper.book Page 24 Friday, June 16, 2017 4:12 PM

Figure 2.4 Front Panel Displays, IW+

Table 2.3 Front Panel Displays, IW+
Item
1 Power Bargraph
2 Numeric Display
3 Up/Down Switches
+ Limit Switch, a
4 2000IW+ only
feature
- Limit Switch, a
5 2000IW+ only
feature
6 Power Indicator
24
Name
This 20 segment bargraph displays the power level
during the Test mode; or the power applied to the
workpiece during a weld cycle. While in the READY
state, the graph displays the peak power of the last
weld cycle. These readings can be expanded by
altering DIP switch settings. When using the 2x scale,
the uppermost segment will blink. Refer to section
4.11.1 Setting DIP Switches
about DIP settings.
During a weld cycle, indicates the current weld state
code, if enabled, or the currently selected parameter's
value. At the end of the weld cycle, it displays alarms.
Once you have selected weld parameters to change,
these four switches increase or decrease your selected
parameters displayed in the NUMERIC DISPLAY. From
left to right, these switches are referred to as the FAST
DOWN switch, the SLOW DOWN SWITCH, the SLOW
UP switch, and the FAST UP switch. Pressing these
switches will have no effect until you have selected
parameters to change. These switches will be disabled
when Display Lock is active.
Selects the maximum value for the mode you are in.
When pressed, the switch LED will light. This switch is
only active after you have pressed MODE.
Selects the minimum value for the mode you are in.
When pressed, the switch LED will light. This switch is
only active after you have pressed MODE.
Indicates that power to welder is ON.
Function
for further information
100-214-251 REV. 05