Figure 4.6 Base Mounting Centers - Emerson Branson 2000 Series Instruction Manual

100-214-251 IWoper.book Page 50 Friday, June 16, 2017 4:12 PM

Figure 4.6 Base Mounting Centers

4.5.2 Mounting the Stand (Welder on Hub-mounted column)
During unpacking, you removed the hub from the column/stand assembly. You must
choose a mounting location for the hub that will support the column and actuator, and
provide the hardware to mount it. Four mounting bolt holes are provided at the corners of
the casting, and will accept your 3/8 inch or M10 hardware. Use flat washers against the
metal casting to prevent gouging. Refer to
CAUTION
50
Figure 4.8 Start Switch Connection
General Warning
The hub must be installed with its front in the same direction as the
front of the welder. The column bolts of the hub are found on the rear
of the hub. See Figure 4.6 Base Mounting Centers
details.
Codes.
for mounting
100-214-251 REV. 05