Figure 4.3 Ultrasonic Converter (J-Type For Stand Use) And Booster - Emerson Branson 2000 Series Instruction Manual

Integrated welder
Table of Contents

Advertisement

100-214-251 IWoper.book Page 43 Friday, June 16, 2017 4:12 PM
1. Move the shipping container close to the intended installation location, leave it on the floor
2. Cut the two vertical packing straps, and open the top of the box. Remove the insert from the top
of the box, which can contain the booster, converter, and the toolkit. Set the insert box aside
3. Remove the staples at the bottom of the protective box. Lift the protective box off the pallet.
Flatten the box and lay it next to the pallet (you will lay the stand on it soon)
CAUTION
4. Cut the packing strap securing the column support to the pallet
CAUTION
5. Remove the block(s) of wood between the base and the support by slowly loosening the two
column clamps (allowing the stand to rise slightly) and then cutting the shipping tape on the
block of wood. RETIGHTEN THE COLUMN CLAMPS
6. Loosen the two hub bolts (for column clamping) on the hub
7. Lift the actuator and column from the pallet. Carefully lay the stand on its right side (NOT ON
THE SIDE WITH THE LINEAR ENCODER)
8. Remove the hub from the pallet and set it aside. Some hubs are bolted to the pallet from the top
9. Unpack the converter, booster, cables, manuals, and toolkit that may be in the insert box. Save
the packing material, including the blocks of wood
10.Go to Section
NOTICE
The packaging may also include the converter and/or booster, if ordered.

Figure 4.3 Ultrasonic Converter (J-Type for stand use) and Booster

(J-type shown)
100-214-251 REV. 05
General Warning
The unit may tend to tip over. Stabilize the stand with the help of an
assistant.
General Warning
The column and column support are under spring tension from the
counterbalance spring. Do NOT attempt to disassemble the column
from the stand, but always keep the column
support clamped together. When making height adjustments,
carefully and slowly release the clamps to control the motion, and
hold the stand to prevent sudden movements or injury.
4.3 Take Inventory of Small Parts
Converter
Booster
43

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Branson 2000iw+

Table of Contents