100-214-251 IWoper.book Page 109 Friday, June 16, 2017 4:12 PM
6.8
Horn Down
Use the following procedure to check you horn-to-fixture alignment and/or Mechanical
Stop Setting:
1. Press HORN DOWN
2. Press the START SWITCHES simultaneously and hold until the TRS is active (indicated by a single
beep). At this point you may release the START SWITCHES
3. To enter READY state and retract the horn, press HORN DOWN again
While you are in HORN DOWN, the NUMERIC DISPLAY will indicate horn travel.
100-214-251 REV. 05
109