horiba HP-200 Instruction Manual page 37

Screen 1 Screen 2 Condition Description
Calibration
data check
screen
Calibration
point check
screen
Zero (STD)
value check
screen
During two-
point
calibration
Span (SLOPE)
value check
screen
Elapsed days
after calibration
screen
Calibration
data check
screen
Calibration
point check
screen
Zero (STD)
value check
screen
During Span
three-point (SLOPE1)
calibration value check
screen
Span
(SLOPE2)
value check
screen
Elapsed days
after calibration
screen
Moving
average count
check screen
(damping
factor)
Action Remarks
Indicates the
calibration points for Note: For manual
calibration data (this input ("PH.Adj"),
display example "Adj" is displayed
assumes two-point on the display part.
calibration)
Indicates
asymmetry
potential (STD) at
pH7 as electric
potential (mV).
Indicates the
sensitivity
(SLOPE) as
electric potential
per 1 pH.
Indicates the
Note: The elapsed
number of
time is accumulated
elapsed days after
only when the
the last
power is ON.
calibration.
Indicates the
calibration points for
calibration data (this
display example
assumes three-
point calibration).
Indicates
asymmetry
potential (STD) at
pH7 as electric
potential (mV).
Indicates the
sensitivity
(SLOPE) for span
1 (SLOPE1) as
electric potential
per 1 pH.
Indicates the
sensitivity (SLOPE)
for span 2 (SLOPE2)
as electric potential
per 1 pH.
Indicates the
Note: The elapsed
number of
time is accumulated
elapsed days after
only when the
the last
power is ON.
calibration.
Note:
Change this
parameter when
the measured
Allows you to value is not
check or set the stable enough.
moving average
If an error occurs
count.
during this setting,
you will exit this
screen with the
previous setting
maintained.
Measurement
29