Display - Setting And Calibration; Travel Speed Calibration - Zetor PROXIMA HS Series Operator's Manual

Display - setting and calibration

Enter the service menu by a longer pressing of button ( A ):
a - Use buttons ( B ) and ( C ) to select the item calibration indicated with arrow.
b - By pressing button ( A ) you enter the calibration menu.
1 - calibration of travelling clutches
2 - calibration of travel speed
3 - setting of the display of the rear PTO shaft speed
4 - service setting
5 - setting of hours
6 - return to the main screen

Travel speed calibration

Dashboard is calibrated after assembly at a production plant.
Do repeated calibration in the following cases:
- after a significant wear of tyres
- when mounting new tyres
- when replacing dashboard
Calibration procedure
- at a suitable place, mark a track of 100 m at length
- inflate tyres of tractor on the prescribed pressure, see tables of this Instructions manual
- start the engine
- move the tractor to the beginning of the 100-metre track
- enter the service menu by pressing (A) button
- select the item (1) by (B) and (C) buttons and by pressing (A) button go to calibration menu
- select the item (2) by (B) and (C) buttons and move to the speed menu by pressing (A) button
- select an item (4) by (B) and (C) buttons and by pressing the (A) button, move to the following menu. The
item (3) serves only for setting the travelling speed in the production plant
- select an item (5) by (B) and (C) buttons and confirm with the (A) button
- start the tractor with a stable speed of approximately 10 km/h
- after travelling the whole distance of 100 m stop the tractor at the marked end of the track (b)
- select the item (6) by pressing the buttons (B) and (C) and by pressing (A) button, save the newly read
values and you will return to initial screen
- if calibration of travelling speed did not run properly, error report will appear on the display (7), after
confirming the item (8) you will return to initial screen by pressing the (A) button without saving the new
values
INSTRUMENT PANEL
PW15N018
PW15N024
61