Table of Contents
Advertisement
Precautions for Safe Use
Precautions for Safe Use
Observe the following precautions when using this product:
Master Unit
(1) Avoid this product from coming in contact with water, oil, solvents, detergents, etc. during transpor-
tation or storage, and make sure it is not subjected to excessive vibrations and impact, or dropped
down. Use a dedicated packaging box when storing this product.
(2) Storage of this product must be within the specified environment. Allow the product to warm up to
room temperature for at least 3 hours after it has been stored at -10°C or lower.
(3) Use the product within the specified temperature and humidity ranges.
(4) Do not use the product under the following locations:
• Locations subject to static electricity, excessive noise, or electric fields.
• Locations where the product may come into contact with water, oil, or chemicals.
• Locations where corrosive gases or flammable gases are present.
• Locations where large amounts of dust or dirt are present.
• Locations subject to spatters, iron chips, or fillings.
• Locations subject to direct sunlight.
(5) To ensure the antenna does not come off during operation, attach it right into the connector.
(6) Do not pull or grab the antenna while carrying or handling the product.
(7) The use of this product at other than the designated frequency is prohibited by the Radio Law. Use
this product after confirming the frequency and product type according to the country of use.
(8) Do not use the product outdoors (outside a control panel).
(9) Tighten the mounting screws to the specified torque of 4.4 to 5.3 in lb. (0.5 to 0.6 N•m)
(10) This product can be mounted at tight contact in the left and right direction, however do not mounted
at tight contact to other heat generating products so as not to obstruct heat release.
(11) Do not use other than the default mounting method.
(12) Doing so may result in the product damaged or malfunction. Do not subject any product to abnor-
mal vibration or shock and dropped it on the floor or otherwise subjected to excessive shock. To
prevent damage from falls, OMRON recommends securing this product with screws when mount-
ing it on walls, etc. Stop using this product if it is subjected to strong impacts.
(13) When mounting the designated antenna with magnet, mount it directly on a steel plate to secure
mounting strength.
(14) When mounting the designated antenna with magnet, do not install the antenna cable together
with the power line or electric cables. Also, do not forcefully pull or bend the cable, or keep any
object on top.
(15) Minor electric shock, fire, or Product failure may occasionally occur. Do not allow any pieces of
metal or conductors or any clippings or cuttings resulting from installation work to enter the Prod-
uct.
(16) Do not apply voltages and to the output Terminals in excess of the maximum switching capacity.
(17) Do not insert more than one wire into each terminal insertion hole.
(18) Do not wire anything to the release holes.
(19) Do not push the terminal block with a force exceeding 40 N when inserting wires or when inserting
a flat-blade screwdriver in a release hole.
(20) Do not bend a wire past its natural bending radius or pull on it with excessive force. Doing so may
cause the wire disconnection.
6
Wireless Pushbutton Switch User's Manual (A265)
Advertisement
Table of Contents
