Omron A2W-R**-WC1 Series User Manual page 66

5 Registration in the ID Mode
 Procedure
1
Set the "mode settings switch" of the Master Unit to "ID" (ID mode).
Mode settings switch
2
Set the "output settings switch" of the Master Unit to (e.g., 1).
Output settings switch
3
The output LED (e.g., OUTPUT 1) of the Master Unit will turn yellow.
OUTPUT 1 turns yellow.
4
Press the Slave button you want to register 3 successive times within 3 seconds.
This assigns the ID of the Slave button to the output number of the Master Unit.
Slave button
Note You can operate it more than three times.
5
The RCV LED of the Master Unit will light green for 3 seconds.
RCV LED
Note If registration fails, the Master Unit's RCV LED will flash green for 3 seconds.
6
Registration complete.
5 - 4
ID
Example 1
Output LED
Operate three times within 3
Lit red
Lit green
Wireless Pushbutton Switch User's Manual (A265)