Starting The Engine Of The Tractor; Blocking Of The Start; Immediately After Start - Zetor CRYSTAL Series Operator's Manual

Starting the engine of the tractor

When starting the engine, it is necessary to sit on the driver's seat.
1. Insert the key to the switchbox ('0' position).
2. Depress the clutch pedal.
3. Shift the main gear shifting lever to neutral position.
4. Shift the reversing lever to neutral position.
5. Make sure that all PTO switches on the right column of the cabin are switched off.
6. Turn the key to 'I' position. A yellow control will light up on the dashboard signalising the proper igniting
function.
7. Wait for the ignition control to turn off (the time is dependent on the temperature of the coolant).
8. Turn the key to the 'II' position (start).
9. After starting the engine, release the key immediately. Do not start for more than 20 sec.

Blocking of the start

If the engine cannot be started and the defect signal lamp is flashing, it means that blocking of the start was
activated by electronic regulation of the engine and this way the engine is protected.
The blocking of the start is interrupted when the key in the switch box for about 30 seconds is moved to
position 0.

Immediately after start

When the engine is started, leave it idling
without load for ca. 2 minutes.
During this time, perform checking of lubrication, charging,
hydrostatic control (signal lamps must not be illuminated)
and other functions ensuring proper operation of the
engine. The time of engine operation without load must be
adhered to, especially in winter period.
DRIVING OPERATION
C15N126
68
FH11N092