Driving Operation; Before You Start; If You Do Not Succeed In Starting The Engine; Non-Permitted Starting - Zetor CRYSTAL Series Operator's Manual

Before a drive with the new tractor get to know how to shift gears and try individual positions
of the shifting lever when the engine is stopped.
During normal operation and before you set up, make sure that the technical condition ensures safe
operation of the tractor.

Before you start

Before you start the engine, make sure that:
1. the tractor is properly braked.
2. the main gear shifting lever of gears in neutral
position.
3. Reversing lever is in neutral position
4. PTO switches are off
If clutch pedal is not depressed the tractor cannot be
started - start protection switch is not switched

If you do not succeed in starting the engine

Return the key to '0' position. Wait 60 second and repeat
the start.
Never help the stopping engine by a starter.
You are being exposed to the danger of starter
damage.

Non-permitted starting

It is forbidden to start the tractor by short-
circuiting the starter clamps. Start only from the
driver´s seat. It is necessary to disconnect minus pole
of accumulator and all the shifting levers including
PTO shaft shifting lever to be shifted in neutral
position with any manipulation or repair of the starter.
The starter´s clams are covered with a cap.

DRIVING OPERATION

67
C15N062
C15N127
C15N125