Zetor CRYSTAL Series Operator's Manual page 47

After about three seconds the main screen is displayed on
the display.
In the main field (1) the travel speed of the tractor is
displayed. In the secondary field (2) the current time in 24-
hour format is displayed.
There are data regarding PTO shafts in this screen.
1. Front PTO shaft revolutions, if the shaft is activated.
2. Rear PTO shaft revolutions, when the shaft is switched
on.
3. Tractor travel speed.
In the main field (1) the total moto hours worked by the
tractor are displayed.
In the secondary field (2) the total moto hours worked by
the tractor from the last resetting of the data are displayed.
In the main field (1) the total kilometres worked by the
tractor are displayed.
In the secondary field (2) the number of kilometres
travelled by the tractor from the last resetting of the data is
displayed.
DASHBOARD
46
C15N031
C15N032
C15N033
C15N034