Switch Box Key In The Position (I); Switch Box Key In The Position (Ii); Tilting And Protrusion Of Steering Wheel; Manual Throttle - Zetor CRYSTAL Series Operator's Manual

Switch box key in the position (I)

The voltage is connected to all the equipment excluding
starter. The key is in this position with the engine running.

Switch box key in the position (II)

Starter and supply of all equipment is connected in this
position apart from wipers, washer, cab ventilator and air
condition. After starting, the key automatically returns back
to 'I' position.

Tilting and protrusion of steering wheel

Tilting column of steering wheel enables variable setting of
position of the steering wheel both in terms of angle and
height.
Height setting of steering wheel
The setting is done by protrusion or retracting the steering
wheel after unlocking arrestment by turning a lever (1) in
the direction of an arrow. After setting the steering wheel,
lock the lever (1) by tightening in the direction of an arrow.
Angle setting of steering wheel
Setting is done by tilting the steering wheel after unlocking
the lock by turning the lever (2) in the direction of the
arrow. After setting the steering wheel, secure the lever
(2) by retightening against the direction of the arrow.

Manual throttle

a - idle run
b - maximum supply
The lever enables to set engine revolutions in the whole
range (a) to (b).
ACQUAINTANCE WITH THE TRACTOR
33
S44
S45
F205