Setting Of The User-Defined Width Of Aggregation; Machined Area Record - Zetor CRYSTAL Series Operator's Manual

DASHBOARD

Setting of the user-defined width of aggregation

C15N105
In the aggregation width menu, each of the three preset values of the aggregation width can be changed.
Enter the aggregation width menu, use buttons (B) and (C) to select the value that you want to change and
press button (A) (ENTER). The value is indicated with asterisk (1).
By pressing of button (D) (DISP), value (a) is indicated with arrow (2); you can change this value using
buttons (B) and (C).
By another pressing of button (D) (DISP), value (b) is indicated with arrow (2); you can change this value
using buttons (B) and (C).
By another pressing of button (D) (DISP), value (c) is indicated with arrow (2); you can change this value
using buttons (B) and (C).
By another pressing of button (D) (DISP) you can exit setting.
To return to the processed area menu, select the item exit using buttons (B) and (C) and press button (A)
(ENTER).

Machined area record

FHD14N070
Enter service menu (a) by longer pressing the (A) button. Select the item machined area marked with an
arrow by (B) and (C) buttons. By pressing the(A) button, you will enter the machined area menu (b).
Select an item (1) by (B) and (C) buttons and in the aggregation width menu select a requested value and
return to the machined area(b) menu.
Select an item (2) by (B) and (C) button and by pressing the button (A) start recording of machined area and
exit service menu. From this time on, if the tractor is moving, machined area will be recorded depending on
the aggregation width and the travelled distance.
The record of the machined area will end if you select item (3) in the machined area menu(b) and press (A)
button.
If you start the record of machined area again, the newly read values will be added to the already saved
values.
After annulling the values in the main and secondary array, select an item (4) in the menu by (B) and (C)
buttons in the machined area menu(b) and by pressing the (A) button, confirm the selection. After returning
to the main screen Machined area, there will not be any data in the main and secondary array of the display
(c).
Overridden values cannot be renewed in any way.
56