Register Data Set In Gprs Mode; Communication Commands According To Din En 62056-21 - SAGEMCOM Dr. Neuhaus ZDUE-GPRS-PLUS-VI User Manual

GPRS Modes

7.5.4 Register data set in GPRS mode

General
Format of the error status

7.5.5 Communication commands according to DIN EN 62056-21

Parameterisation commands
Service commands
R3 commands:
Page 60 of 63
As being described in Section 7.4.4.
The error status format is described in Section 6.4.2.
The ZDUE-GPRS-PLUS-VI in GPRS-IP-Telemetry mode supports the same
communication commands as in CSD mode. There are also GPRS-specific
commands; these are listed in the following.
The three parameter classes 70, 76 and 78 additionally contained in the
ZDUE-GPRS-PLUS-VI for GPRS-IP-Telemetry mode are configured
according to the parameterisation of the ZDUE-GPRS-PLUS-VI standard
classes (see 6.5.3) and saved to non-volatile memory in the device using the
parameter transfer command (see 6.5.4).
1. Reading GPRS operating parameters
Command format: <SOH>R3<STX>S96(12)<ETX><BCC>
Reply format: <STX>S96(12)(LocalIP)(NetMask)(Gateway)(DNS1)(D
NS2) <ETX><BCC>
The parameters have the following meaning here:
LocalIP IP address currently assigned to the device. If the device
currently has no address assigned to it, "000.000.000.000" is
output.
NetMask This value remains empty
Gateway This value remains empty
DNS1 Current DNS1
DNS2 Current DNS2
ZDUE-GPRS-PLUS-VI